Tesla Cybertruck SNAPPLATE Front License Plate Mount, Removable, 2023-2024

• Tesla Cybertruck 2023, 2024
• FREE SHIPPING to the lower 48 states
• Patent-pending SnapPlate removable front license plate mount installs and completely removes in seconds!
• Paint-safe, Grille-safe, Radiator-safe, Autopilot-safe
• For US plates (12'X6")
• Clean, minimal design blends perfectly with the Cybertruck front end
• Plate sits low and tight on the bumper to avoid showing up on the camera
• Mount installs and completely removes in seconds (remove for touch car washes!)
• Includes security screw and driver to prevent removal and deter theft
• Includes five black and four silver T25 torx security screws, T10/T25 screwdriver, and felt case
• Easy installation!

Patent-pending SnapPlate removable front license plate mount installs and completely removes in seconds. The clean, minimal design blends perfectly with the Tesla Cybertruck front end when it’s installed, leaves no unsightly hardware behind when it’s removed, and the exclusive breakaway plate mount breaks away under stress to protect the grille on the car where it attaches.

Hanging a license plate off the front of the plastic grille is actually pretty dangerous for the grille and grille replacements are expensive. To make SnapPlate grille-safe, it is designed it to break away if it is stressed by car washes, fender benders, vandals, etc.

Each Snap Plate comes with:

• One fully-assembled front license plate mount, ready for your license plate
• Four black and four silver torx security screws for the plate
• One black torx security screw to optionally secure it to the car
• One torx security screwdriver to keep in the car
• One zippered case to keep all the accessories tidy in your car

Snap Plate is perfect to:

• Remove your plate for car shows
• Install to avoid tickets while parked at a meter
• Remove to clean your car at home or at a car wash
• Install for toll-by-plate roads and bridges
• Deter theft with torx security screws on the plate and mount
• Install a temporary plate to support your favorite team on game day

Easy Installation and Removal in Seconds:

To install SnapPlate:

1. Push the left side of the front to rotate the latches open
2. Line it up with the center of the grille
3. Plug it in
4. Push the bottom of front to rotate the latches closed (internal magnets keep it closed)
5. Done
6. Optionally, if you want additional security, use the included screwdriver to install the black security screw into the hole on the right side

To remove SnapPlate:

1. Loosen the security screw, if you’re using it
2. Push the left side of the front to open the latches
3. Unplug
4. Nothing left behind

Trust EV Parts Online for all your Tesla Model 3 needs!